ICOM IC-7200 . SINGLE BAND TRANSMITTER ICOM HF 50 Mhz Completely designed for use in expeditions, the new Icom IC-7200 does not hide its explorer aspect, giving an image of a tough and strong team. It covers the HF and 50 MHz bands and has an intermediate frequency DSP. The output power is 100 watts. Taking into account that it is developed for use in activations outside the usual base, it has been provided with handles (optional) to facilitate transport. It also resists the intrusion of water so it can be used outdoors.  MAIN FEATURES DSP Incorporates DSP technology. Thanks to this function the Icom IC-7200 is comparable to its superiors. AGC MANAGEMENT LOOP
Distortion and blocking of strong nearby signals is prevented thanks to the DSP functions inside the AGC. AGC time constants can be selected from fast, slow, and off for each operating mode from fast, slow, and off for each operating mode.  DIGITAL FILTER
They will never require optional filters for the IC-7200. Built-in digital filter allows you the flexibility to select filter width and shape soft or hard
* The filter is only selectable for SSB and CW modes.  MANUAL NOISE FILTER
The manual noise filter delivers over 70dB of attenuation.
Strong burying tones will be eliminated without affecting the performance of the AGC. At the bottom right of the front panel, you will find a control button dedicated to adjusting the filter frequency.
TWIN DIGITAL PBT
Only Icom brings you the Twin Digital PBT! Adapt your bandwidth with the PBT electronically by changing the top and bottom edges of the filter. Depending on the use of the concentric knobs, you can either narrow the IF passband, or change the entire passband to eliminate intrusive signals. NOISY DIGITAL REDUCTION
Digital Noise Reduction reduces background noise and improves the signal-to-noise ratio. The noise reduction level is adjustable in 16 steps. This improves the readability of voice and data signals. DIGITAL NOISE BLANKER
The digital noise blanker reduces pulse-type noise like starting a motor. The level and width (duration cutoff) are adjustable in 100 steps. HIGH TRANSMITTER STABILITY
The DDA (Department for Disarmament Affairs) creates a clear and clean signal transmission and improves the C / N ratio. With a dual cooling system, the IC-7200 provides stable high quality output even during high duty factor operation.  USB PORT FOR CONTROL FROM PC
The IC-7200 can be controlled by a personal computer through a USB port that uses the IC-V data format. In addition, the modulator and received audio can also be transferred over the USB cable. Using the appropriate external software, you can record incoming calls and / or transmit pre-programmed messages from your personal computer.
RF SPEECH COMPRESSOR
The digital RF compressor increases your average talk power in SSB mode. Even when the compression level is higher, the DSP RF compressor provides low audio distortion. MODE OF OPERATION CW
Selectable CW carrier point (USB OR LSB) and adjustable CW fretboard is also standard. WATER RESISTANT CHASSIS
The waterproof protection technologies that are used in Icom marine radios are applied to the buttons and knobs on the front panel to provide a measure of protection against water intrusion.
* IC-7200 is not waterproof. STURDY DESIGN FOR OUTDOOR USE
The rugged design of the IC-7200 means that your enjoyment is not limited to just one use at home. "REAR BUMPER"
The "rear bumper" protects various connectors on the rear panel and lets you support the radio at its rear end when the antenna is disconnected, for example to move or package the radio.  OTHER FEATURES
* RIT
* VOX
* 0.5ppm frequency stability
* LCD backlight (Hi / Lo / Off)
* IC-V interface
* 201 memory channels
* Built with 20dB attenuator
* Preamplifier
* Dial lock
* Automatic TS function
* 1Hz step tuning
* Band stacking record
* Voice synthesizer
* Quick cleft
* Front speaker
* Quick setting mode | 
